Mammoth Tank 3D Printing Model | Assembly Kit

Mammoth Tank 3D printing model is the pride of our designers for the opulence and impressiveness of the model. It is known that every guy is attracted to war vehicles. This one will definitely become hugely popular among 3D print fans as it has everything a war tank should have: it is powerfully armored, it is equipped with deadly weaponry and missiles and it is huge in size and can destroy the foe with one shot only.

Our designers have considered every tiny detail of the well-known fighter, but also enhanced it with additional elements to make it look more brutal, and transferred them to this model. You will enjoy a very detailed assembly model, with 103 parts to print and join together. The joining elements between two parts are there for assembly reference for the user. However, the parts must also be glued together.

The model is 430mm wide, 151mm tall and 212mm deep.

To buy Mammoth tank 3D printing files, hit the green “Buy” button at the top-right corner and proceed to checkout by adding your PayPal account or credit card details.

Build your own war tank with Gambody!

Generic

This model was tested in Cura 15.06. To avoid printing problems, we recommend:

Quality:

• Layer height: 0.1mm
• Initial layer thickness: 0.3mm
• Bottom/top pattern: Lines
• Horizontal expansion 0.04mm (when entering 0.04 index, the 3D printer perceives the model as monolith, i.e. as having no hidden layers).

Check this Simplify3D User Guidelines to avoid any 3D printing problems with this software.

Speed setups:

• Infill speed: 50mm/s
• Outer shell speed: 30mm/s
• Inner shell speed: 20mm/s
• Top/Bottom speed: 20mm/s
• Support speed: 50mm/s
• Travel speed: 150mm/s
• Skirt speed: 30mm/s
• Amount of slower layers: 4

Infill:

• Infill pattern: Grid
• Line distance: 3 mm
• Infill overlap: 20%
• Infill layers: 0

Support:

• Enable support – Check
• Placement: Everywhere
• Overhang angle: 30°
• X/Y distance: 0.7mm
• Top distance: 0.2mm
• Bottom distance: 0.2mm
• Stair step height: 0.5mm
• Join distance: 0.7mm
• Area smoothing: 0.6mm
• Use towers: Check
• Pattern: Lines
• Line distance: 1.5mm

Platform Adhesion

• Type: Brim 
• Brim line count: 7 (up to 20, depending on the model’s height)

The model has been tested in PLA.

Recommendations:

All parts will be printed on the build plate in such a way as to save PLA material, to keep to print pattern and to cut printing time, while avoiding quality loss. It is not recommended to set higher printing speed for T2 - T13 (Tower) parts, because 
they are fragile parts and require slower and quality printing.

It is recommended to increase layer printing speed from standard 5 sec to 8-10 sec for T8, T10, T11, and T12 parts, to allow time for plastic on small printing parts to cool. This operation can be avoided if several parts of the model are being printed simultaneously on the build plate. 

Avoid increasing speed for CT1 - CT8 (Caterpillar tracks) parts as they consist of small elements, positioned closely together. Otherwise, the result will not be clean and will show outer defects. You can set several parts to be printed simultaneously on the build plate.